top of page

Honeycomb Dehumidifying Dryer 

Honeycomb Dehumidifying Dryer (DHC)

Our honeycomb dehumidifiers with desiccant wheel/rotor are designed to make the perfect drying of plastics and resins due to its excellent dew point control, below -40°C . 

FEATURES

  • Import Honeycomb of ceramic fiber  , exceed dew point below -40°C of dried air

  • Intelligent Microprocessor Control and premium overheat protector.

  • Accurate PID temperature controller.

  • Well designed Solid State Relay(SSR) and protective devices.

SPECIFICATION

Honeycomb Dehumidifying Dryer
Honeycomb Dehumidifying Dryer

REMARKS

 

  • We reserve the right to change the technical data without prior notice.

  • Customized specifications are available upon your early inquiry.

  • If your Dehumidifying Dryer works with more than one suction hopper, suggest to upgrade one level of your blower.

STANDARD ACCESSORIES

  • Intelligent P.I.D. digital temperature controller

  • Temp. display of outlet air 

  • Water shortage alarm

  • Motor reverse protector

  • Motor overload protector

  • Overheat preventer

  • No-circuit switch

OPTION

Oil Eliminator

01

Oil Eliminator

  • YANN BANG oil eliminator replaces the generic filter which can’t eliminate the hot gas. Using this patented (Taiwan M327784) oil eliminator can prevent the hot oil gas entering into the desiccant dryer and prolong life of honeycomb wheel and desiccative.

02. Electrical Microprocessor Control
Temperature, Humidity, Dew Point detector devices
03. Dew-point meter
04. Heat-resistant silicone pipe accessories
05. Dust-free & insulated hopper dryer (DHD)
06. Insulated hopper dryer(IHD)

FAQ

Dehumidifying Dryer

    1. Check both of Dehumidifying dryer and Hopper dryer if they are suitable.

    2. Check both of DHM (DHC) and HD if they have air leakage.

    3. Check if the raw material contains oil or added. 

    4. The function of desiccant and honey comb rotor is unstable for dehumidify or regeneration.

    5. Evaporator blocked, heating element fault or regeneration temperature is too low.

  • Check the spares of PU-TR, timer 60M x 12S, PU-NC, SENSOR, compressor air source…etc. Check it step by step to solve the failure.

  • It may EGO error or breakdown. Thermal bar poor assembling and poor contact causes overheat of temperature controller and SSR failure.

  • To replace temperature controller, auto computing and adjust PID.

  • Check cooling water, filter, evaporator and cooler.

bottom of page